MediaWiki:Sitenotice:
2024-03-02: The wiki ran out of disk space, so things were not working. This has been resolved by adding another 5GB of quota ;-) Thanks to Tim Lindner for reporting the issues.
2020-05-17: If a page gives you an error about some revision not being found, just EDIT the page and the old page should appear in the editor. If it does, just SAVE that and the page should be restored. OS-9 Al (talk) 12:22, 17 May 2020 (CDT)
File:Internal HDB-DOS Eprom Upgrade PCB installed into a Korean Coco 2B.jpg
Original file (1,536 × 2,048 pixels, file size: 542 KB, MIME type: image/jpeg)
The Internal HDB-DOS Eprom Upgrade PCB is shown installed in a Korean Coco 2B in its first successful test configuration. Notice the red wire in the 14 pin socket. Its purpose is to pass the chip select signal on to the 27128 eprom. The blue wire connects pin 27 (programming mode enable, an active low pin) of the eprom is connected to pin 28 of the Eprom which provides +5V to keep the eprom out of programming mode. The orange wire is not connected to anything since HDB-DOS is not being tested yet.
File history
Click on a date/time to view the file as it appeared at that time.
Date/Time | Thumbnail | Dimensions | User | Comment | |
---|---|---|---|---|---|
current | 05:26, 24 October 2013 | 1,536 × 2,048 (542 KB) | Computerdoc (talk | contribs) | The Internal HDB-DOS Eprom Upgrade PCB is shown installed in a Korean Coco 2B in its first successful test configuration. Notice the red wire in the 14 pin socket. Its purpose is to pass the chip select signal on to the 27128 eprom. The blue wire co... |
You cannot overwrite this file.
File usage
The following page uses this file: